@TheCyclist wrote:
I created a grid of points and they are at different elevations depending on the location of three attractor points. Because there are three attractor points, there are three groups consisting the points that are closest to each attractor point. I now need to create a surface from the elevated points, but the SrfGrid is ‘reading’ the points in the wrong order causing the surface to warp wildly. I first attempted to sort the points, and that is helping, but the SrfGrid still isn’t seeing them correctly.
I’ve attached my condensed GH file. You’ll see the points that are elevated in the Z and then the same points duplicated at Z=0. Disregard the pts @ z=0. I’m just trying to figure out how to create a surface from the points conforming the attractor points (which are internalized).grasshopper_forum.gh (16.3 KB)
Posts: 4
Participants: 2