@sarupria.saket wrote:
Hello all,
My aim is very simple - to sum values from multiple panels. Conventionally I would have to plug in each component one by one in the mass addition component. My question is - is there any way to select all my panels and say connect all these to the input of the mass addition component. If it was one set I wouldn’t have bothered, just did it straight away. However I have a lot of groups with several panels of which I want to take the sum individually. Refer image below for a better picture -
Something like what Galapagos has. You select all your sliders and right click on the Genome, say selected slider and bam…all are connected.
From what I understand this is something which is a part of the architecture of Galapagos. Grasshopper doesn’t have such a functionality built-in.
Any help is much appreciated. Unfortunately I don’t code. An idea to come up with a component perhaps… something similar to Control Wire Display component.
Thanks!
Regards
Saket
Posts: 15
Participants: 5