Unroll for surface new idea

@blitz.dmitriy wrote:

I saw the idea for unrolling the surfaces and decided to implement.

Unroll.jpg1000x1254 109 KB

Lines to the surface edges are created from the center point on the surface. Then, a point is created on the plane from which the lines originate at the same angles. Distances are measured on the lines and a curve is created at the end points.
Faced with the problem of creating the shortest curves from the center point to the edge of the surface at a given angle.
Please help.

Lines.gh (5.2 KB)
Cerves.3dm (48.0 KB)

Posts: 4

Participants: 3

Read full topic