Loft problem: it's lofting the old points, not the new ones

@s3662825 wrote:

Hi there!
I’ve tried and tried but I’m not sure how to fix this problem.
I’m trying to parametrically modify the points on all these curves, apart from the ends points, and then loft the new curves into a surface. After finally managing the first part, I’m now stuck here.

help 3.jpg1587x759 742 KB

As you can see, the loft in orange is based off the old coordinates, not the new, modified points. I’ve attached the rhino and grasshopper files. Any help would be welcome

flow test.gh (16.0 KB)
flow.3dm (45.8 KB)

Posts: 3

Participants: 2

Read full topic