@TheCyclist wrote:
I have two sets of curves—one on the outside and another on the inside. They all together form in a circle.
The issue is when you look at the listed order of the two sets, they are not synced up. I’ve attached an image of what I’d like to do. Basically it is to loft the outside curves to their complimentary inside curve. This should result in 816 shelf-like surfaces.
What would be the best means of syncing these curves together to create a proper loft?
2018.05.11_mcneel_forum.gh (1.7 MB)
Posts: 4
Participants: 2