Issues with dimensions and text in Rhino 5 (but the same Grasshopper document in Rhino 6 is perfectly fine)

@robinmouwen wrote:

Hi,

I have a two views that I would like to Draft on to a seperate page.
All the generated geometries, text and dimensions are created in Grasshopper, nothing is done in Rhino.

However I get different results in Rhino 5 and Rhino 6.

This is my draft in Rhino 6, as I intended it.

Rhino 6.PNG967x738 15.1 KB

And this is the same Grasshopper document in a Rhino 5 draft (with grey background)
Note that the actual viewports are similar to what you can see on the picture in Rhino 6. However, whenever I want to create a new page/draft. This stuff happens with my text and dimensions.

Rhino 5.PNG992x700 9.35 KB

Adjusting the dimension size for the draft in Rhino 5 doesn’t give what I want, because the might be ok then but then the arrows of the dimensions are so small u can’t even see them.

Are Grasshopper dimensions handled differently in Rhino 5 vs Rhino 6?

Rhino 5 Draft.3dm (19.8 KB)
Rhino 6 Draft.3dm (34.4 KB)
Grasshopper Document.gh (359.5 KB)

Posts: 5

Participants: 3

Read full topic