@svillanueva1091 wrote:
Hi everyone, I’m working on creating an image sampler on some louvers and got somewhere pretty decent.
I’ve run into 3 areas that I would gladly have your help/advice.
Louvers - I based them off a grid and lofted at the end which might not have been the best method.
I would like to have better control of the louvers. Specifically Spacing, thickness, min max depth, size of grid and orient to Z plane.Boundaries of image sampler
I think the sampling is working and doing what i want it to, but I cant get it to fit within my boundaries. See image for detailed explanation.Clunkiness
I’m still learning grasshopper so i might be doing things really inefficient. This is causing my grasshopper changes to take about a 30-45 seconds to load on rhino.Please excuse the poor quality images. Grasshopper file attached below as well. Rhino units are set to Inches.
Image being sampled
IMAGE ATTRACTOR.gh (56.1 KB)
Posts: 2
Participants: 2