@mikel.zvb wrote:
Hi all, this might be a stupid problem, but I have no idea what I’m doing wrong. I’m doing Ray tracing for a project at work and I have everything set up in Grasshopper for Ray tracing but for some reason it’s only working in some specific surfaces and not for the rest of them despite the fact that some of them are located in the same working plane and only a few meters apart from each other. I set a "Point component at the end of the BouncePts section of the Raytracing Component and I’m getting points for all the surfaces I add but only Bounces in a few of them. Below you have an image of the code in Grasshopper.
I’m also attaching the file from Grasshopper. Unfortunately, I can’t attach the File from Rhino, as it is too big, nor the weather/location file (The analysis is based in London)
2186-01 RAY TRACING.gh (386.4 KB)I would appreciate if someone could have a look at it and let me know what is going on.
Thanks!
Posts: 3
Participants: 3