@makandrei97 wrote:
Hello everyone
I am trying to copy a custom pattern which is made by a series of curves and then offset them depending on another curve that acts like an attractor so that the closest the pattern center is to the attractor, the thinner the curves will be and the further, the thicker.
It seems like the only curves from the pattern that are working on this principle are the 2 circles and the other curves just stay the same.
This is a picture of the idea I want to use:
What is the problem? initial pattern.3dm (59.6 KB)
thickness change.gh (11.8 KB)
Posts: 2
Participants: 2