@Matthew_Kneale wrote:
Hi,
I'm trying to build a post and beam pavilion structure using Grasshopper. However, I'm not sure how to make the horizontal beams have a rectangular profile. In the screenshot below I've used the Pipe component as a placeholder until I figure it out.
I tried using the Bounding Box component around the pipes, but this just put boxes around each sub-square of four beams [if that makes sense?].
Do you have any tips on making the horizontal beams have a square profile?
Thanks in advance for any assistance,
Matthew[Also, just to give credit to the reference project: it's Testing Grounds in Melbourne, Australia]
170326_Post_And_Beam_Pavilion.3dm (439.7 KB)
170326_Post_And_Beam_Pavilion.gh (19.0 KB)
Posts: 2
Participants: 2