Cull Index Issue - List Item 0 Gives weird Integer

@alexglafkos wrote:

Hello to everyone.

I know a lot of people say this at the beginning of almost every question, but I also have a problem which might seem dumb and/or super easy. Therefore please excuse my ignorance.

What I am struggling with is that I am using List Item to extract the first item (0) of a list and instead of getting that as an integer, I come out with a weird number (223).
To further elaborate on my process, I use Pufferfish to tween the two guiding curves of a surface (after I have done a clean up of the initial surface) and then I want to use the Pinch and spread component on all the -so to say- “internal” tweened curves. Thus, I would like to remove from the tween result the initial guiding curves by using cull index.

Any ideas?

Thank you in advance.
Alex

Cull Index Issue from List Item.gh (29.4 KB)

Posts: 4

Participants: 2

Read full topic