@Gaurav_Chauhan wrote:
Hello,
I obtained the following surface from a set of scanned data using Geomagic Design X. Surface.igs (322.3 KB)
I was trying to morph a hex pattern on the extracted surface and got the following result
The pattern seems so tight and distorted around the highlighted area. I have tried to rebuild the surface but still the same result. Is there a way that we can evenly morph a pattern onto a surface like this? Some method to evenly distribute the pattern evenly on the surface and achieve something the image?
Thank You and I have attached the code.
(I used ‘CreateUVCrv’ command in Rhino to extract a planar surface and then get the pattern on it.)
Experiment.gh (17.7 KB)
Posts: 2
Participants: 2