@Vanessa_Clem wrote:
Hi everyone.
I am trying to do something simple but I confront some issues.I am trying to pipe some closed curves but the pipes are broken and don’t follow along the curves everywhere.
I assume this happens because of the curvature of the curve and the given radius. Is there a possible solution on that?
If not, I don’t mind if the radius of the pipe varies and gets thinner where the curve turns around (since I want a more organic look), so I tried in T-splines with no success. Is there another plug-in or way of doing so?Thanks a lot!pipe issue.gh (4.2 KB)
pipe issue.3dm (110.8 KB)
Posts: 3
Participants: 3