@siemen wrote:
Since there is no Serengeti - Grasshopper1 topic I’ll post it here:
Here’s a weird problem I’m getting in grasshopper for Rhino 5 as well as Rhino 6 beta.
When I try to fillet these curves with a radius of 3.00 mm it doesn’t work for a few curves and gives me the following error: 1. Solution exception:Object reference not set to an instance of an object.
When I try with a radius of 2.99 (or below) or 3.01 (or above) it works without a problem.
NOW. When I change it back to 3.00 and move the same curves which are linked in Rhino -20mm in Y-direction: It magically works.
What causes this and can it be fixed without having to switch diameter or move the original curves?
171112 Fillet error.gh (5.3 KB)
171112 Fillet error gh.3dm (45.3 KB)
Posts: 3
Participants: 1